ZPIO
Wireless repeater of analogue and discrete signals
Wireless repeater of analogue and discrete signals
ZPIO eliminates cable connections and simplify your installations.
State on the inputs is copied automatically on the outputs of the remote module.
ZPIO replace cable connecting the signal transmitter and the receiver by reliable wireless connection. Data delivery between ZPIO modules is guaranteed by the applied protocol for transmission with confirmation, standard IEEE 802.15.4 and ZigBee.
ZPIO allow to control remote analogue and discrete outputs and/or to get information about the discrete and analogue inputs.
WHY ZPIO?
• Get over rivers, roads, railways and other obstacles without
need of any construction works
• Easy and fast installation
• Reliable work inside and outside
• Low maintenance costs due to lack of cables
Features:
• Up to 8 I/O, optically isolated
• Peer-to-Peer mode of communication between two ZPIO modules
• Range up 4 km at line-of-sight condition
• Frequency—2.400 to 2.485 GHz
• RF Data rate – 250 000 bps
• Modulation – O-QPSK, DSSS
• Max. output power 60 mW (100 mW EIRP), software adjustment
• IP65 protection against moisture and dust
• Wide temperature range:–200C ÷ +600C
• Power supply 220 VAC or 24 VDC, built-in lightning protection
• Free configuration software.
• Peer-to-Peer mode of communication between two ZPIO modules
• Range up 4 km at line-of-sight condition
• Frequency—2.400 to 2.485 GHz
• RF Data rate – 250 000 bps
• Modulation – O-QPSK, DSSS
• Max. output power 60 mW (100 mW EIRP), software adjustment
• IP65 protection against moisture and dust
• Wide temperature range:–200C ÷ +600C
• Power supply 220 VAC or 24 VDC, built-in lightning protection
• Free configuration software.
Ordering code: ZPIO - A BC-D, where:
ZPIO - Wireless repeater for I/ O signals (parrot) under standard IEEE802.15.4, RF data rate 250Kbps, range 2400-2485MHz, O-QPSK modulation and DSSS spread spectrum
A - POWER SUPPLY
1 - 220VAC
2 - 24VDC
3 - 12VDC
D - ANTENNA or CONNECTOR
0 - Internal omnidirectional whip 1.5 dBi - up to 200m
1 - External omnidirectional whip 5 dBi - up to 500m
2 - Antenna connector type N(f) - up to 4 km
BC - BUILD-IN INPUTS/ OUTPUTS
11 - Four ÷ eight inputs selectable for dry contact or DC key—common "-". Up to four outputs - common "-", open collector.
12 - Up to four inputs for dry contact or DC key—common "-". Four ÷ eight outputs selectable—common "-", open collector.
13 - Two inputs 4-20mA, 10bits, optical insulation between inputs and internal bus. Two outputs 4-20mA, 10bits, optically non-insulated, 2-wire connection, passive.
14 - Two DI for dry contact and two relay outputs.
21 - Five general DI for dry contact or DC key. Two alarm inputs. One DI for accumulator voltage.
22 - Three general DI for dry contact or DC key. Two alarm inputs. One DI for accumulator voltage. Bypassed one internal input and one internal output for radio link control.
APPLICATION EXAMPLES:
